Bearings / 607
607 bearing — 7 × 19 × 6 mm
Size 7 × 19 × 6 mm · single row deep groove ball bearing, miniature, 60 series. Dimensions are the same in every brand (ISO 15).
| Dimensions | mm | inches |
|---|---|---|
| Bore (d) | 7 | 0.2756 |
| Outside diameter (D) | 19 | 0.748 |
| Width (B) | 6 | 0.2362 |
How to read the number
60 = series · 7 = 7 mm bore (on miniature bearings the last digit is the bore).
Most common versions
| Version | Number |
|---|---|
| Open | 607 |
| Metal shields | 607-2Z / ZZ |
| Rubber seals | 607-2RS / 2RSH / DDU / LLU |
| Snap ring groove | 607-N / NR |
| C3 clearance (motors) | 607 C3 |
- Metal shields on both sides (2Z / ZZ). Greased for life; keep out coarse dirt with no drag, good for high rpm.
- Rubber seals on both sides (2RS / DDU / LLU). Greased for life; best protection against fine dust and water, with slightly more drag and lower max rpm than shields.
- C3: internal clearance greater than normal. For tight fits or high temperature; very common in electric motors.
Brand equivalents
| Brand | With metal shields | With rubber seals |
|---|---|---|
| SKF | 607-2Z | 607-2RSH |
| FAG / Schaeffler | 607-2ZR | 607-2RSR |
| NSK | 607-ZZ | 607-DDU |
| NTN | 607-ZZ | 607-LLU |
| Koyo | 607-ZZ | 607-2RS |
Usual designations of each manufacturer; the size is the same in all of them. Check the brand's catalog.
Shaft and housing fit
Most common case, inner ring rotating with the shaft under normal load: shaft Ø7 j6 and housing Ø19 H7. If the outer ring rotates (wheels, idler pulleys) it is reversed: shaft g6 or h6 and housing M7 or N7. Check the manufacturer's catalog for heavy loads or high temperatures.
Keyed 7 mm shaft? DIN 6885 calls for a 2 × 2 mm key →
Related bearings
Same bore (7 mm), other series: 627 (7×22×7) · 637 (7×26×9)