Bearings / 6908
6908 bearing — 40 × 62 × 12 mm
Size 40 × 62 × 12 mm · single row deep groove ball bearing, 619 series (thin section). Dimensions are the same in every brand (ISO 15).
| Dimensions | mm | inches |
|---|---|---|
| Bore (d) | 40 | 1.5748 |
| Outside diameter (D) | 62 | 2.4409 |
| Width (B) | 12 | 0.4724 |
How to read the number
69 = series · 08 × 5 = 40 mm bore.
Most common versions
| Version | Number |
|---|---|
| Open | 6908 |
| Metal shields | 6908-2Z / ZZ |
| Rubber seals | 6908-2RS / 2RSH / DDU / LLU |
| Snap ring groove | 6908-N / NR |
| C3 clearance (motors) | 6908 C3 |
- Metal shields on both sides (2Z / ZZ). Greased for life; keep out coarse dirt with no drag, good for high rpm.
- Rubber seals on both sides (2RS / DDU / LLU). Greased for life; best protection against fine dust and water, with slightly more drag and lower max rpm than shields.
- C3: internal clearance greater than normal. For tight fits or high temperature; very common in electric motors.
Brand equivalents
| Brand | With metal shields | With rubber seals |
|---|---|---|
| SKF | 6908-2Z | 6908-2RSH |
| FAG / Schaeffler | 6908-2ZR | 6908-2RSR |
| NSK | 6908-ZZ | 6908-DDU |
| NTN | 6908-ZZ | 6908-LLU |
| Koyo | 6908-ZZ | 6908-2RS |
Usual designations of each manufacturer; the size is the same in all of them. Check the brand's catalog.
Shaft and housing fit
Most common case, inner ring rotating with the shaft under normal load: shaft Ø40 k5 and housing Ø62 H7. If the outer ring rotates (wheels, idler pulleys) it is reversed: shaft g6 or h6 and housing M7 or N7. Check the manufacturer's catalog for heavy loads or high temperatures.
Keyed 40 mm shaft? DIN 6885 calls for a 12 × 8 mm key →
Related bearings
Same bore (40 mm), other series: 6808 (40×52×7) · 6008 (40×68×15) · 6208 (40×80×18) · 6308 (40×90×23)
← 6907 (Previous in the series) · 6909 → (Next in the series)