Bearings / 6806
6806 bearing — 30 × 42 × 7 mm
Size 30 × 42 × 7 mm · single row deep groove ball bearing, 618 series (ultra-thin section). Dimensions are the same in every brand (ISO 15).
| Dimensions | mm | inches |
|---|---|---|
| Bore (d) | 30 | 1.1811 |
| Outside diameter (D) | 42 | 1.6535 |
| Width (B) | 7 | 0.2756 |
How to read the number
68 = series · 06 × 5 = 30 mm bore.
Most common versions
| Version | Number |
|---|---|
| Open | 6806 |
| Metal shields | 6806-2Z / ZZ |
| Rubber seals | 6806-2RS / 2RSH / DDU / LLU |
| Snap ring groove | 6806-N / NR |
| C3 clearance (motors) | 6806 C3 |
- Metal shields on both sides (2Z / ZZ). Greased for life; keep out coarse dirt with no drag, good for high rpm.
- Rubber seals on both sides (2RS / DDU / LLU). Greased for life; best protection against fine dust and water, with slightly more drag and lower max rpm than shields.
- C3: internal clearance greater than normal. For tight fits or high temperature; very common in electric motors.
Brand equivalents
| Brand | With metal shields | With rubber seals |
|---|---|---|
| SKF | 6806-2Z | 6806-2RSH |
| FAG / Schaeffler | 6806-2ZR | 6806-2RSR |
| NSK | 6806-ZZ | 6806-DDU |
| NTN | 6806-ZZ | 6806-LLU |
| Koyo | 6806-ZZ | 6806-2RS |
Usual designations of each manufacturer; the size is the same in all of them. Check the brand's catalog.
Shaft and housing fit
Most common case, inner ring rotating with the shaft under normal load: shaft Ø30 k5 and housing Ø42 H7. If the outer ring rotates (wheels, idler pulleys) it is reversed: shaft g6 or h6 and housing M7 or N7. Check the manufacturer's catalog for heavy loads or high temperatures.
Keyed 30 mm shaft? DIN 6885 calls for a 8 × 7 mm key →
Related bearings
Same bore (30 mm), other series: 6906 (30×47×9) · 6006 (30×55×13) · 6206 (30×62×16) · 6306 (30×72×19)
← 6805 (Previous in the series) · 6807 → (Next in the series)