Bearings / 6011
6011 bearing — 55 × 90 × 18 mm
Size 55 × 90 × 18 mm · single row deep groove ball bearing, 60 series (light). Dimensions are the same in every brand (ISO 15).
| Dimensions | mm | inches |
|---|---|---|
| Bore (d) | 55 | 2.1654 |
| Outside diameter (D) | 90 | 3.5433 |
| Width (B) | 18 | 0.7087 |
How to read the number
60 = series · 11 × 5 = 55 mm bore.
Most common versions
| Version | Number |
|---|---|
| Open | 6011 |
| Metal shields | 6011-2Z / ZZ |
| Rubber seals | 6011-2RS / 2RSH / DDU / LLU |
| Snap ring groove | 6011-N / NR |
| C3 clearance (motors) | 6011 C3 |
- Metal shields on both sides (2Z / ZZ). Greased for life; keep out coarse dirt with no drag, good for high rpm.
- Rubber seals on both sides (2RS / DDU / LLU). Greased for life; best protection against fine dust and water, with slightly more drag and lower max rpm than shields.
- C3: internal clearance greater than normal. For tight fits or high temperature; very common in electric motors.
Brand equivalents
| Brand | With metal shields | With rubber seals |
|---|---|---|
| SKF | 6011-2Z | 6011-2RSH |
| FAG / Schaeffler | 6011-2ZR | 6011-2RSR |
| NSK | 6011-ZZ | 6011-DDU |
| NTN | 6011-ZZ | 6011-LLU |
| Koyo | 6011-ZZ | 6011-2RS |
Usual designations of each manufacturer; the size is the same in all of them. Check the brand's catalog.
Shaft and housing fit
Most common case, inner ring rotating with the shaft under normal load: shaft Ø55 k5 and housing Ø90 H7. If the outer ring rotates (wheels, idler pulleys) it is reversed: shaft g6 or h6 and housing M7 or N7. Check the manufacturer's catalog for heavy loads or high temperatures.
Keyed 55 mm shaft? DIN 6885 calls for a 16 × 10 mm key →
Related bearings
Same bore (55 mm), other series: 6211 (55×100×21) · 6311 (55×120×29)
← 6010 (Previous in the series) · 6012 → (Next in the series)